Cut bead board to size, mine is 20″ long x 11 1/2″ tall.
Measure + cut trim to size, I used a Ryobi miter saw, 4 quick cuts!
Paint trim brown, I used DecoArt’s “Raw Umber”. Don’t forget the edges of your bead board too!
Screw bead board to trim from the back of the bead board using 1/2″ screws.
Apply stencil (I used BellMT font/bold) and paint inside red.
After the letters are dry, sand down the inside wood for a distressed look.
Use bakers twine to hang the wreath discreetly behind the frame, tack into place.
Hang and display and you’re done!